Operation Manual

PAGE 13
2. “TX POWER MIDDLE” indicates Tx power is middle.
3. “TX POWER LOW” indicates TX power is low.
 In Channel number mode, the user is not allowed to change
TX power manually.
• Offset
Keep pressing and then buttons to choose either OFF-
SET+/OFFSET-/ OFFSET OFF.
1. “OFFSET+” indicates plus offset Transmitting frequency is higher
than receiving frequency.
2. “OFFSET-” indicates minus offset Transmitting frequency is lower
than receiving frequency.
3. “OFFSET OFF” indicates shut offset off.
• Band-Width Selection
Keep pressing and then buttons to choose bandwidth
among 25K/20K/12.5K.
1. “W/N 25K” indicates wide band.
2. “W/N 20K” indicates middle band.
3.“W/N 12.5K” indicates narrow band.
 In Channel number mode, the user is not allowed to change
band width manually.
• Voice Compander
Keep pressing and then buttons to switch COMPANDER
ON or OFF.
“COMPANDER ON” : Compander feature is activated.
“COMPANDER OFF”: Compander feature is not activated.
• Reverse TX/RX
Keep pressing and then buttons to switch REVERSE ON
or OFF.