Operation Manual

PAGE 26
12.5KHz.
• Reverse TX/RX
TX frequency turns to RX frequency & RX frequency change to TX
frequency. The signaling will also be reversed if CTCSS/DCS signal-
ing existed in this channel.
1. Press button to get into channel menu.
2. Press button repeatedly or press Up/Down key on extended
microphone till LCD shows “REVERSE”
3. Rotate power knob to set ON/OFF reverse frequency.
4. ON: enable frequency reverse; OFF: disable frequency reverse
 This function will be disabled while “Talk around” function
is enabled.
• Talk Around
By Talk Around function, you can directly communicate with other
radios in your group in case the repeater is not activated or when you
are out of the repeater range. The transceiver will transmit by RX
frequency with its CTCSS/DCS signaling.
1. Press button to get into channel menu.
2. Press button repeatedly or press Up/Down key on extended
microphone till LCD shows “Talk Around”.
3. Rotate power knob to switch ON or OFF.
4. ON: talk around enabled; OFF: talk around disabled.
 Default: OFF
• TX Off Setup
PTT is invalid and the current channel works in RX mode.
1. Press button to get into channel menu.
2. Press button repeatedly or press Up/Down key on extended