Installation - Horizontal/Vertical Vent Outlet Owner's manual
Form I-F/B250/300/400, PN 102860 (Rev 2), Page 1
WARNING: Improper installation, adjust-
ment, alteration, service, or maintenance can
cause property damage, injury or death. Read
the installation, operation, and maintenance
instructions thoroughly before installing or
servicing this equipment.
HORIZONTAL/VERTICAL
VENT OUTLET
Installation Form RZ-NA I-F/B250/300/400-HV
Obsoletes Form 434-HV (Version 1)
Applies to: Model F 250, 300, and 400 and
Model B 250, 300, and 400
®
Model F and B 250, 300, and 400 unit heaters require field assembly of the vent outlet. Using the 26 , #10 x
1/2 sheetmetal screws (24 in the plastic bag and the two screws used to hold the flue outlet pieces in place
during shipping), carefully follow the illustrated instructions on page 2 to assemble the outlet vent.
DANGER: Failure to provide proper venting could result in death, serious injury,
and /or property damage. The unit must be installed with a vent connection and proper
vent to the outside of the building. Follow the instructions on page 2 and the venting
instructions in the installation manual.
SEE PAGE 2
! CAUTION:
THIS HEATER
REQUIRES ASSEMBLY
OF FLUE OUTLET.
REFER TO
INSTRUCTIONS ON
THIS SHEET.
! CAUTION:
THIS HEATER
REQUIRES ASSEMBLY
OF FLUE OUTLET.
REFER TO
INSTRUCTIONS ON
THIS SHEET.