Installation - Filter Cabinet User guide
Form I-CAUA-FC, P/N166162R2, Page 7
STEP 1 Parts Required:
2 Filter Cabinet Door (or Side) Channels
1 Filter Support (NOTE: Refer to the illustration and select
carefully as there is a lter support and a lter channel for
the horizontal (rear) inlet conguration that will not be used
when assembling the lter cabinet with a vertical (top) inlet.)
1 Filter Cabinet Bottom Panel
8 Screws from the Package
Instructions (Refer to Illustration):
1) Using the "preparation" holes drilled in the heater cabinet
(FIGURE 2A or 2B) and screws from the kit, attach the two
cabinet door channels as illustrated.
2) Remove the row of screws above the cutout area. Position
the lter support over the holes (as illustrated). Re-insert
the screws, securing the lter support to the heater cabinet.
3) Remove the screws along the bottom edge of the heater
cabinet. Position the lter cabinet bottom panel against
the heater cabinet. Re-insert the screws attaching the lter
cabinet bottom to the heater cabinet.
STEP 2 Parts Required:
1 Filter Cabinet Side Panel
1 Filter Cabinet Bottom Rear Panel
8 or 9 Screws from the Package
Instructions (Refer to Illustration):
1) One end of the lter cabinet will have an attached side
panel, and the other will have a removable door panel.
On the end that is selected for the permanently attached
panel, use screws to secure the side panel to the
channel attached in STEP 1.
2) Position the bottom rear panel; attach to the side panel
and the bottom panel.
STEP 3 Parts Required:
1 Filter Cabinet Rear Top
Panel
1 Filter Cabinet Top Inlet
Panel (with duct ange)
1 Filter Support
1 Filter Channel Assy
2 Corner Support Braces
22 or 24 Screws from the Pkg
Instructions (Refer to the illustrations):
1) Position the rear top panel; attach to the side panel and the rear bottom panel.
2) Position the top inlet panel; attach to the rear top panel.
3) Reach inside the cabinet and attach the top inlet panel to the heater.
4) Position the lter support against the rear panel as illustrated. Attach with
screws.
5) Position the lter channel assembly across the inlet opening and attach with
screws.
6) To add structural support to the cabinet, position a triangular corner support
brace in the bottom outer corner on the door end of the cabinet. Fasten with two
screws. Position and attach the other corner brace in the top outer corner.