Installation Manual User guide

4.4 Installing the EFMA Floor Heating System

Tape, spray adhesive, stapler

Remove the product from the box and verify the electrical and insulation

resistance of the heating cable.

heating cable

junction

channel

cold lead

Fig. 4.4 a

• Unroll the mat, adhesive side down (Fig. 4.4 a);

• Ensure that the cold lead is long enough to be connected to the thermostat or

junction box;

• To minimize oor height, chisel a 10mmX10mmX250mm (

”X

”X10”)

channel in the suboor to receive the cold lead/heating cable (black) junction.

e junction has an extra insulation sheath and a slightly larger diameter than the

heating cable;

• Continue to unroll the EFMA system on the oor, working around the stationary

elements marked out beforehand (see Section 4.4.1);

• As needed, reposition EFMA: its adhesive allows it to be positioned more than

once.

• You may use hot glue or tape to fasten the EFMA to the suboor;