Installation Manual User guide

20
4.5 Installing the Temperature Sensor
Hot glue gun, hammer, wood chisel or concrete chisel
channel
temperature
sensor
Fig. 4.5
• To minimize oor height, chisel a 10mmX10 mmX250mm (
3
/
8
”X
3
/
8
”X10”)
channel in the suboor to receive the temperature sensor.
CAUTION!
e sensor must be embedded in cement or an equivalent binder (cement glue,
ceramic glue, self-levelling cement).
• Glue the sensor to the suboor (Fig. 4.5). e sensor must be solidly fastened to
the suboor to ensure it stays in place when the cement or an equivalent binder
(cement glue, ceramic glue, self-levelling cement) is applied.