Installation Manual
Table Of Contents
- 1.0 General
- 1.1 Hazard Labels and Notices
- 1.2 General Information
- 1.3 Warranty
- 1.4 Installation Codes
- 2.0 Location
- 2.1 Recommended Mounting Height and Distance from a Wall
- 2.2 Ventilation Requirements
- 3.0 Receiving
- 4.0 Dimensions and Clearances
- 4.1 Dimensions
- 4.2 Clearances
- 5.0 Suspending the Unit
- 6.0 Gas Supply
- 6.1 Gas Supply Line (Refer to FIGURE 6.)
- 6.2 Gas Pressure
- 7.0 Electrical
- 7.1 Electrical Supply
- 7.2 Electrical Requirements by Voltage and Control Types
- 7.3 Wiring Diagrams
- 8.0 Ignition and Operation
- 9.0 Commissioning and Startup
- 10.0 Accessories
- 11.0 Maintenance and Service
- 11.1 Maintenance Procedures and Illustrations
- 11.2 Troubleshooting Guide
- Index
- INSTALLATION RECORD - to be completed by the installer:
Optional wire grid
to increase radiant
efciency
10.0 Accessories
Heat Deector, Option DO2
A heat deector is available on Sizes 30-100 to permit less clearance above the heater.
See Paragraph 4.
Chain and "S" Hooks, Option UE1
Option kit includes 50 ft (15M) of 200 lb (91 kg) chain and 14 "S" hooks.
Chain Mounting Kit, Option UE2
Option kit includes assembled chain and "S" hooks for mounting one unit (See FIGURE
4, page 8).
Gas Connector and Shutoff Valve, Option UF2
Option kit includes a 24" stainless steel gas connector and shutoff valve.
Standard
Reector
Optional Screen
The following are eld-installed accessories. Follow the instructions shipped with the
option package.
Thermostat, Option CL34 is a 24/120 volt thermostat that can be used to control
1-5 units. This thermostat can also be used to control the exhaust fan circuit.
Thermostat, Option CL82 is a 24-volt, 2-stage digital thermostat that can be
used with Option AG2R for automatic control of 1-5 units.
Parabolic Reector, Option DM2
The addition of the parabolic reector
increases the infrared intensity pattern
while decreasing the scope of heating
coverage.
Installation affects clearances and mounting height; see page 7.
Wire Grid, Option DN2
Available on all sizes except
RIHN 30.
Required on Canadian
installation of
Model RIHN 60.
Protective Screen, Option DN3
This screen is designed to protect the
ceramic block from damage caused by
the entrance of foreign objects.
(NOTE: Not for use with parabolic
reector, Option DM2. If protective
screen is required with parabolic
reector, contact factory.)
Form I-RIH, P/N 131793R8, Page 16