UDX Venting Instructions
Table Of Contents
- VENTING INSTRUCTIONS FOR UNIT HEATERS (MODEL UBX: STANDARD POWER VENT BLOWER TYPE AND MODEL UDX: STANDARD POWER VENT FAN TYPE)
- GENERAL INFORMATION
- INSTALLATION
- Instructions for Commercial/Industrial Installations (Model UBX or UDX, All Unit Sizes)
- Instructions for Residential Installations (Model UDX, Unit Sizes 030, 045, 060, 075, 100, 125)
- Instructions for Commercial/Industrial or Residential Installations (Model UDX, Unit Sizes 030, 045, 060, 075, Vertical Category I)
- APPENDIX A: INSTRUCTIONS FOR ATTACHING DOUBLE-WALL TYPE B VENT PIPE TO SINGLE-WALL PIPE
- APPENDIX B: INSTRUCTIONS FOR INSTALLING FLEX-L BRANDCATEGORY III VENT PIPE
- FIGURES
- Figure 1. Roof Slope and Pitch
- Figure 2. Horizontal Vent Terminal (Commercial/Industrial Installations)
- Figure 3. Vertical Vent Terminal (Commercial/Industrial Installations)
- Figure 4. Horizontal Vent Terminal (Residential Installations)
- Figure 5. Vertical Vent Terminal (Residential Installations)
- Figure B1. Reducer and Vent Cap
- TABLES
8
CP-UBX-UDX-VENT (03-21) 1034631-0
INSTALLATION—CONTINUED
Instructions for Residential Installations (Model UDX,
Unit Sizes 030, 045, 060, 075, 100, 125)—Continued
Figure 5. Vertical Vent Terminal (Residential Installations)
Figure 4. Horizontal Vent Terminal (Residential Installations)
c. Refer to instructions shown in Figure 5 to install vertical vent terminal.
d. Ensure that vent terminal is installed in accordance with Vent Terminal (Type of Pipe and Vent Cap)
Requirements section.