Operating instructions

1104UESAGBEN, page 7/31

The heater is supplied with four point suspension. All points must be used.

Threaded nut inserts are provided on each side of the top panel of the heater.

See ﬁ gure below.

5. HANGING THE

HEATER

Before suspending the heater check the supporting structure to be used to

verify that it has sufﬁ cient load-carrying capacity to support the weight of the

unit. Suspend the heater only from the threaded nut inserts. Do not suspend

from the heater cabinet.

When the heater is lifted for suspension, leave the unit on the pallet. Before

hanging, verify that all screws originally used to ﬁ x the shipping supports, are

rescrewed into the cabinet.

WARNING

Unit must be level for proper

operation. Do not place or

add additional weight to the

suspended heater.

UESA 035 055 083 102

kg 148 151 222 230

Table 2:

Weight (kg)

Figure 2:

Suspending the heater

with rods from the

threaded nut inserts

Be sure that the threaded hanger rods are locked to the heater as illustrated in

ﬁ gure 2. Recommended maximum hanger rod length is 1.8m. Where longer

drops are required, ensure that restraints are ﬁ tted to prevent excess lateral

movement and supports are adequately sized.

Add a nut to lock the

M10x1.5 hanger rod to the

heater

Alternatively the unit can also be base mounted on a non-combustible sup-

port. In this case ensure that unit is securely ﬁ xed on the base.