User's Manual

© Copyright 2003-2005 RF Code, Inc. All rights reserved. UM-C2020-R05-20030422.
No copying of this material is allowed without prior written permission. Page 13 of 28.
13
USER MANUAL – Mantis™ II Reader
U
WARNING – Computer administrative privileges are recommended
when using the Network-Enabled Reader Programmer utility. In the
event of IP resolution conflicts, the Utility will attempt to modify the
Address Resolution Protocol (ARP) table. On some systems, this can
only be achieved with sufficient privileges.
To launch the utility and perform a Reader setup or update:
Step 1 – From the Windows® desktop, go to the Start button > Programs
> RF Code > Mantis II Reader program group. Click the Configure
Mantis II Reader option to launch the utility.
Step 2 – The Network-Enabled Reader Programmer utility appears in a
DOS screen (see Figure 3.1 above). Refer to the settings below:
• Reader Settings – Refer to page 14.
• Network Settings – Refer to page 15.
• Advanced Network Settings – Refer to page 16.
• Programming Options – Refer to page 17.
• Network Installation – Refer to the example on page 18.