User's Manual

© Copyright 2003-2005 RF Code, Inc. All rights reserved. UM-C2020-R05-20030422.
No copying of this material is allowed without prior written permission. Page 18 of 28.
18
USER MANUAL – Mantis™ II Reader
Configuration Files & Default Settings
Each Reader has a configuration file under SSI_info\AXnnnnnn.txt (where
AXnnnnnn is the serial number) reflecting its last programmed state. After
a successful program upload to a Reader, the configuration file for that
Reader is updated with the current settings.
The next time the Reader is selected for configuration, these saved settings
are imported and displayed as a baseline configuration. The Reader
configuration file is therefore purposely similar to the interactive commands.
U
WARNING – Do not use [CTRL]+[C] to exit, or the last settings of the
Mantis™ II Reader will be lost!
Example – Network Installation
Step 1 – Select the (R) command, then enter the Reader’s serial number
when prompted.
Step 2 – Select the (I) command, then enter the new IP address for the
Reader (e.g. 192.168.4.34).
Step 3 – Select the (S) command, then enter the new subnet mask for the
Reader (e.g. 255.255.0.0).
Step 4 – Select the (F) command to upload the new file system and update
the Reader settings.