User's Manual

No copying of this material is allowed without prior written permission. Page 27 of 28.

USER MANUAL – Mantis™ II Reader

C – FCC Compliance

Changes or modifications to this equipment, not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection

against harmful interference when the equipment is operated in a residential installation. This

equipment generates uses and can radiate radio frequency energy and, if not installed and used

in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee against interference to radio or television reception, which may

be determined by turning the equipment off and on; the user must try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

• Operation of this equipment in a residential area is likely to cause harmful interference

in which case the user will be required to correct the interference at his/her own

expense.

The Mantis™ II System has two major components which are independently certified and

comply with Federal Communications Commission (FCC) rules, part 15.

This Mantis™ II Reader complies with part 15 of the FCC rules. Operation is subject to the

following two conditions: (1) this device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired

operation.

The system operates by using Mantis™ Tags which have been certified or are in the

certification process. These devices comply with part 15 of the FCC rules. Operation is subject

to the following two conditions: (1) these devices may not cause harmful interference, and (2)

these devices must accept any interference received, including interference that may cause

undesired operation.

a. FCC IDs: N3S2001B03 for:

i. 2 second Mantis Tag P/N: 05101297-26

ii. 5 second Mantis Tag P/N: 05101297-27

iii. 10 second Mantis Tag P/N: 05101297-28

iv. 15 second Mantis Tag P/N: 05101297-29.

b. FCC IDs: P6F2001C04 for:

i. Mantis Tags with motion sensor P/N 05101677-01

(containing PCB level P/N 02021663-01)

ii. Mantis Tags W/O motion sensor P/N 05101677-11

(containing PCB level P/N 02021663-11)