User's Manual

CS-490 NA BESPA User Manual Rev2.0 - Part # 11900-439 Aug 2020
2
Introduction
This BESPA™ User Guide provides the basic information needed to install an individual
BESPA antenna unit containing an RFC-445B RFID Reader CCA. This guide is not intended
to provide instructions for installing, configuring and calibrating the RF Controls Intelligent
Tracking and Control System (ITCS™). For additional information about RF Controls, LLC
antennas, contact [e-mail].
INTENDED AUDIENCE
This guide is intended for those who will install and set up the RF Controls BESPA
(Bidirectional Electronically Steerable Phased Array) unit. Before attempting to install,
configure and operate this product, you should be familiar with the following:
• Windows based software installation and operation
• Device communication parameters including Ethernet and serial communications
• RFID reader configuration including antenna placement and RF Parameters
• Electrical and RF safety procedures.
Table of Contents
-BESPA Overview ............................................................................................................................... 3
-Indicator LEDs .................................................................................................................................... 4
-INSTALLATION .................................................................................................................................. 5
-Mechanical Installation ................................................................................................................. 5
-Electrical Installation .................................................................................................................... 5
-SOFTWARE ....................................................................................................................................... 7
-SPECIFICATIONS ............................................................................................................................. 7
-SAFETY INSTRUCTIONS Consignes de Sécurité .............................................................. 8
FCC NOTICE
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
The BESPA products and individual BESPA components are protected by
one or more US and International Patents pending.
https://rf-controls.com/legal-notice/
The “RF Controls” logo, and the words “RF Controls, Identify, Locate, Track”, “ITCS”, and
“BESPA” are registered Trademarks of RF Controls, LLC.