User's Manual

CS-490 NA BESPA User Manual Rev2.0 - Part # 11900-439 Aug 2020
8
-SAFETY INSTRUCTIONS Consignes de Sécurité
This unit emits Radio Frequency non-ionizing radiation. The installer must ensure that the
antenna is located or pointed such that it does not create an RF field in excess of that
permitted by the Health and Safety Regulations applicable to the country of installation.
Cet appareil émet Radio Fréquence rayonnements non ionisants. L'installateur doit s'assurer
que l'antenne est située ou orientée de façon à ne pas créer un champ RF supérieure à celle
permise par le Règlement sur la santé et applicable dans le pays d' installation.
Setting RF Output Power
Enter the desired RF output power as a percentage of the maximum power into the Set
Power box. Click the set Power button. Note: the actual maximum Radiated RF Power is
factory set to comply with the radio regulations in the country of use. In the USA and Canada
this is 36dBm or 4 Watts EiRP. Model#: CS-490 NA
Saisie de la puissance de sortie RF souhaité sous forme d' un pourcentage de la puissance
maximale dans la zone d'alimentation Set. Cliquez sur le bouton ensemble d'alimentation .
Remarque: le maximum réel rayonnée de puissance RF est réglé en usine pour se conformer
à la réglementation de radio dans le pays d'utilisation. Aux Etats-Unis et au Canada c'est 4
Watts EiRP.
FCC and IC Radiation Exposure Statement
The antenna used on this equipment must be installed to provide a separation distance of at
least 34cm from all persons and must not be co-located or operated in conjunction with
another antenna or transmitter. The criteria used to evaluate the environmental impact of
human exposure to radio-frequency (RF) radiation is specified in FCC Part 1 SUBPART I &
PART 2 SUBPART J §1.107(b), Limits for General Population/Uncontrolled Exposure. This
antenna meets INDUSTRY CANADA RSS 102 ISSUE 5, the SAR and RF field strength limits
in Health Canada’s RF exposure guideline, Safety Code 6 for Devices used by the General
Public (Uncontrolled Environment).
L'antenne utilisée sur cet équipement doit être installée de manière à assurer une distance
de séparation d'au moins 34 cm de toute personne et ne doit pas être co-localisée ou utilisée
avec une autre antenne ou un autre émetteur. Les critères utilisés pour évaluer l'impact
environnemental de l'exposition des personnes aux rayonnements RF sont spécifiés dans la
partie 1 des FCC, sous-parties I et 2, sous-parties J §1.107 (b), Limites pour une population
générale / exposition non contrôlée. Cette antenne est conforme à la norme RSS 102
NUMÉRO 5 d’INDUSTRIE CANADA, concernant les limites de champ DAS et RF dans les
lignes directrices de Santé Canada sur l’exposition aux RF, Code de sécurité 6 pour les
appareils utilisés par le grand public (environnement non contrôlé).
FCC Part 15 Notice
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.