Installation Instructions

SASL User Guide v1.10 - Part # 11400-431 October 2015
9
-SAFETY INSTRUCTIONS Consignes de Sécurité
This unit emits Radio Frequency non-ionizing radiation. The installer must ensure that the antenna
is located or pointed such that it does not create an RF field in excess of that permitted by the
Health and Safety Regulations applicable to the country of installation.
Cet appareil émet Radio Fréquence rayonnements non ionisants. L'installateur doit s'assurer que
l'antenne est située ou orientée de façon à ne pas créer un champ RF supérieure à celle permise
par le Règlement sur la santé et applicable dans le pays d' installation.
Setting RF Output Power
Enter the desired RF output power as a percentage of the maximum power into the Set Power box.
Click the set Power button. Note: the actual maximum Radiated RF Power is factory set to comply
with the radio regulations in the country of use. In the USA and Canada this is 4 Watts EiRP and
under EN 302 208 this is 2 Watts ERP (3.2 W EiRP).
Entrer la puissance de sortie RF souhaité sous forme d' un pourcentage de la puissance maximale
dans la zone d'alimentation Set. Cliquez sur le bouton ensemble d'alimentation . Remarque: le
maximum réel rayonnée de puissance RF est réglé en usine pour se conformer à la réglementation
de radio dans le pays d'utilisation. Aux Etats-Unis et au Canada c'est 4 Watts EiRP et selon la
norme EN 302 208 c'est 2 watts ( 3,2 W PIRE).
FCC Radiation Exposure Statement
The antenna used on this equipment must be installed to provide a separation distance of at least
23cm from all persons and must not be co-located or operated in conjunction with another antenna
or transmitter.
L'antenne utilisée sur cet équipement doit être installé pour fournir une distance de séparation d'au
moins 23cm de toutes les personnes et ne doit pas être co- implantés ou exploités conjointement
avec une autre antenne ou émetteur .
FCC Part 15 Notice
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
FCC and Industry Canada Modification Warning Statement
Modification of this device is strictly prohibited. Any modifications to the factory hardware or
software settings of this device will void all warranties and be deemed non-compliant with FCC and
Industry Canada Regulations.
La modification de ce dispositif est strictement interdite. Toutes les modifications apportées au
matériel d'usine ou les paramètres du logiciel de cet appareil annulera toutes les garanties et sera
considérée comme non conforme aux normes FCC et d'Industry Canada.