User's Manual

ManualsBrandsRF Ideas ManualsElectronicsMulti Protocol USB RFID Reader

12

Chapter

2

Hardware

Reader Set-Up

Basics

Plug

the

connector

into the

workstation’s

(or

available on any peripheral) open

RS-232, USB

or

Ethernet

plug.

Place

the

device next

to the

monit

or

,

beside

the

workstation,

or

where

appropriate.

The workstation should detect new hardware

for

USB

connections.

Verify the

workstation

r

ec

ogniz

es

this

connection using Device

Manager’.

Verify the

correct

COM port for

RS-232 DB9 connections using ‘Device

Manag

er

.

’

When the

software

is

installed,

it

should recognize these connections

in

order

to

configure

the

appropriate device. Once

the

device

is

configured and

written to its

flash

memory

,

these settings

will

not

have

to

be configured

again.

LED

Beeper

The desk

t

op

,

USB dongle,

wall

mount, and bare board

(OEM)

model readers are

all

equipped

with

a

light

up LED on

the front

cover. The LED

is

configurable through

the utility

software

(

See

LED

and

Beeper functions

in the

Sof

t

w

ar

e

section)

to

allow

the

device

to

produce a beep upon

light

up

of the

LED when a credential

is

detected

by the

r

eader

.