Owner`s manual

WAVECOM

Sr. owner’s manual 8

How to transmit audio/video from your satellite

receiver or laser disc player

You can transmit audio/video either directly from your satellite receiver or laser disc

player, or by connecting them to your VCR. To transmit directly from your satellite

receiver or laser disc player, follow the instructions below.

Step 1. Make sure the WAVECOM

Sr. ON/OFF switch is in the OFF position.

Connect one set of audio/video (A/V) cables to the A/V jacks of the

transmitter and to the AUDIO/VIDEO OUT jacks of the satellite receiver

or laser disc player. Be sure the yellow, red and white plugs match the

yellow, red and white jacks on both the satellite receiver/laser disc player

and the transmitter.

Step 2. Plug one end of the provided power adapter into the back of the

WAVECOM

Sr. transmitter and the other end into any 120-volt wall

outlet. Turn the ON/OFF switch to ON position and indicator light should

go on.

Step 3. If your satellite receiver or laser disc player has only one set of A/V output

jacks, and you had to disconnect your TV from those jacks to connect

WAVECOM

Sr., reconnect the TV by connecting coaxial cable from the

single VHF/UHF OUT port on the satellite receiver or laser disc player to

the VHF/UHF IN port on your TV.

Step 4. Locate and orient the transmitter according to the chapter of this manual

titled “Orienting Units for Optimal Performance.”