Owner`s manual

WAVECOM
TM
Sr. owner’s manual 19
How to receive audio on your remote powered
speakers
Since WAVECOM
TM
Sr. only receive stereo signals and does not amplify them,
the speakers you use to enjoy wireless sound must be self-powered or attached to
an amplifier or stereo receiver.
To use self-powered speakers, such as computer speakers, follow the instructions
below.
Step 1. Obtain a mini stereo phono jack-to-stereo RCA adapter at your local
electronics store. Make sure the WAVECOM
TM
Sr. ON/OFF switch is in
the OFF position. Connect the red and white A/V plugs of the adapter to
the red and white audio jacks of the receiver.
Step 2. Connect the plug at the end of the right speaker wire to the main stereo
phone jack on the adapter.
Step 3. Plug the wire leading from the left speaker into the back of the right
speaker to enjoy full stereo sound.
Step 4. Plug one end of the provided power adapter into the back of the
WAVECOM
TM
Sr. receiver and the other end into any 120-volt wall outlet.
Turn the ON/OFF switch to ON position and indicator light should go on.
Step 5. Locate and orient the WAVECOM
TM
Sr. receiver according to the chapter
of this manual titled “Orienting Units for Optimal Performance.”