Owner`s manual

WAVECOM

Sr. owner’s manual 20

How to receive audio on any remote speakers

You can enjoy wireless sound without using powered speakers as long as you use an

amplifier or stereo receiver to boost the signal from the WAVECOM

Sr. receiver.

This feature allows you to listen to a multiple-CD changer or other audio source on a

stereo in another room.

Step 1. Make sure the WAVECOM

Sr. ON/OFF switch is in the OFF position.

Connect one set of A/V cables to the two audio jacks (red and white only)

of the receiver and to the IN 1 or IN 2 jacks on your stereo receiver or

amplifier. Be sure the red and white plugs match the red and white jacks

on the WAVECOM

Sr. receiver and the stereo receiver or amplifier.

The yellow video plug is not used.

Step 2. Run speaker wire from your stereo receiver or amplifier to your speakers as

you normally would.

Step 3. Plug one end of the provided power adapter into the back of the

WAVECOM

Sr. receiver and the other end into any 120-volt wall outlet.

Turn the ON/OFF switch to ON position and indicator light should go on.

Step 4. Locate and orient the WAVECOM

Sr. receiver according to the chapter

of this manual titled “Orienting units for optimal performance.”