Owner`s manual

WAVECOM

Sr. owner’s manual 7

How to transmit audio/video from your cable TV

hookup

To transmit your cable TV channels, you must have either a VCR or a cable converter

box. If you use a VCR, follow the instructions on the previous page for transmitting

from your VCR. To use your cable converter box, follow the instruction below.

Step 1. Make sure the WAVECOM

Sr. ON/OFF switch is in the OFF position.

Connect one set of audio/video (A/V) cables to the A/V jacks of the

transmitter and to the A/V jacks on the back of your cable converter box.

Be sure the yellow, red and white plugs match the yellow, red and white

jacks on both the converter box and the transmitter. If the converter box

has only one output for audio (mono sound only), connect one white plug

to that single audio output and the other to transmitter’s AUDIO LEFT

jack.

Step 2. Plug one end of the provided power adapter into the back of the

WAVECOM

Sr. transmitter and the other end into any 120-volt wall

outlet. Turn the ON/OFF switch to ON position and indicator light should

go on.

Step 3. To view your cable signal on a nearby TV, connect coaxial cable from the

single OUT port on the cable converter box to the VHF/UHF IN port on

your TV.

Step 4. Locate and orient the transmitter according to the chapter of this manual

titled “Orienting Units for Optimal Performance.”