User's Manual

ECLIPSE2 IPCommander User Manual
18
discarded and the current settings retained.
5.3. Logging (Syslog)
The Eclipse2 has a built-in Syslog client conforming to the RFC3164 protocol.
When enabled the Eclipse2 will send messages to a Syslog Server or Host using a
specified IP address and severity level.
• Enable Logging: Click on check box to enable logging
.
• Host: Enter the IP address of the Syslog Server that will receive the messages.
• Min Severity: Specifies the level of the message type.
There are eight message types:
Level 0. Emergency
Level 1. Alert
Level 2. Critical
Level 3. Error
Level 4. Warning
Level 5. Notice
Level 6. Informational
Level 7. Debug
5.4. Versions
Displays the current software, hardware and database version numbers.
5.5. Exciter Transmit Power
Displays the current Exciter RF Power Output in Watts.
The Exciter has an RF power output of 0.1 watt to 5 watts, set via the Power field.
To change the Exciter TX power, enter the required power level and click the “Apply”
button. Valid power levels are from 0.1 to 5 watts in 0.1 watt increments.
5.6. Reciter Temperature
Displays the current free air temperature inside the reciter module.
5.7. RX Path