User's Manual

ECLIPSE2 IPCommander User Manual
38
7.9. TX P25
The TX P25 tab allows the user to choose whether to repeat the incoming NAC or override
with a user defined TX NAC code.
7.10. TX CWID
The TX CWID tab allows the user to set the period between CWID identifiers, the speed
of the Morse Code, the frequency of the CW tone used and the message being sent.
The ID field is used to set the Morse code message to be transmitted. It can be up to
20 characters in length, and contain the characters A-Z, 0-9 and the punctuation
characters shown in
Table 1. Lower case letters will be converted to upper case.
The Tone field sets the frequency of the tone used to transmit the Morse code, in units
of hertz.
The Morse Speed field controls the speed at which the Morse code is transmitted. It is
in units of words per minute, where the word being transmitted is PARIS.
The TX Interval field controls the period between each CWID identifier. It is in units of
seconds, and may take a value up to 9999 seconds.
A detailed description, of the operation of the CWID block, is in section 6.2.28.
7.11. Trace
The Trace menu displays low-level internal software messages from the Reciter Module.
These messages can be saved to a log file and used for diagnostic purposes.
Figure 15 Trace Panel