Installation Instructions

15
Operating and installation instructions RF-KIT Power Amplifier RF2K-S
Output Power Calibration
The output power generated at a given control power can be adjusted op-
tionally within certain limits for each bandpass range.
The 6 m band requires a higher control power than the
other frequency ranges and should therefore always be set
to “100“.
Selection of the bandpass range is done automatically during transmission.
The detected band is highlighted.
► Adjust the Forward Power by pressing the buttons
> (increase value) or < (decrease value).
Short actuation changes Calibration Value by 1 digit.
Longer actuation changes the Calibration Value continuously (factory
setting: 100.0).
Indication area Forward Power constantly informs you about the current
-
ly generated output power.
► Press the switching area Save to store the settings.
► Repeat this procedure for each bandpass range to be adjusted.
Indication area Band
Switching area >
(increase value)
Indication area
Calibration Value
Switching area <
(decrease value)
Switching area Close
Touching this switching area closes the user menu;
subsequently the main screen will be displayed
Switching area Save
Touching this switching area
stores the settings
Indication area Forward Power