User's Manual

Rev 1.3
USER MANUAL - TRANSMITTER DS SERIES - 30 - 50 - 100 - 300 - 500 - 1000W
12
Technical Specifi cations
GENERAL
Power Output: 50W (typ. 55W), 100W (typ. 110W), 300W
(typ. 330), 500W (typ. 550W), 1000W (typ. 1100W),
adjustable from front panel.
RF Output Impedance: 50 ohm.
RF Output Connector: “N”(50-300W), “7/16”(500-
1000W) type.
Monitor RF: BNC connector.
Frequency Range: 87.5 ÷ 108.00 MHz, only for analog
on request 66 ÷ 74 MHz ( OIRT), 76 ÷ 90 MHz (JPN)
Programmable in 10 kHz steps.
Frequency Stability: ±1 ppm from -5 to 45°C.
Off Lock A enua on: ≥ -80 dBc.
Modula on Capability: ±150 KHz.
Limiter built in
Power Good Detector: adjustable from20÷90% of the
power.
Audio Presence Detector: adjustable  me from front
panel.
External AGC: Automa c, with fi ne ADJ from front panel.
Modula on Mode: Mono, Stereo, Mul plex, SCA, RDS,
Aux.
Preemphasis: Flat/50/75µs selectable from front panel.
Asynchronous AM S/N Ra o: -70 dB.
Synchronous AM S/N Ra o: -65 dB .
RF Harmonics: Exceeds EBU/CCIR/FCC requirements.
RF Spurious: Exceeds EBU/CCIR/FCC requirements.
MONAURAL OPERATION
Audio Input Impedance: 600 ohm - ≥10 Kohm balanced.
Audio Input Level: DS series -6 to +12 dBm
Input Connector: XLR female.
Audio Frequency Response: ±0.1 dB, 30 Hz to 15 KHz.
Total HarmonicDistor on + Noise: 0.1% @ 400 Hz.
Intermodula on Distor on: 0.1%, 1 KHz/1.3 KHz, 1:1
ra o.
Transient Intermodula on Distor on: 0.1% 2.96KHz
square wave and 14 KHz sine wave.
Distor on: 0.1% 2.96KHz square wave and 14 KHz sine
wave.
FM S/N Ra o: -85 dB rms detector,-80 dB below ±75 KHz
devia on.
STEREO OPERATION
Audio Input Impedance: 600 ohm - ≥10 Kohm balanced.
Audio Input Level: DS series -6 to +12 dBm
Input Connector: XLR female.
Audio Frequency Response: ±0.1 dB, 30 Hz to 15 KHz.
Total HarmonicDistor on + Noise: 0.1% @ 400 Hz.
Intermodula on Distor on: 0.1%, 1 KHz/1.3 KHz, 1:1
ra o.
Transient Intermodula on Distor on: 0,1% 2.96KHz
square wave and 14 KHz sine wave.
FM S/N Ra o: -85 dB rms detector, -80 dB below ±75 KHz
devia on.
Stereo Separa on: analog -45 dB@30Hz ≥ -60dB@ Freq
≥ 100 Hz
Crosstalk a enua on: digital Main to Sub -70 dB 30 Hz to
15 KHz, analog ≥ 45 dB@15kHz.
38 KHz Suppression: ≥ -85 dB.
Pilot Frequency: 19 KHz ± 1 Hz
Output Pilot: DP series 1 Vpp. BNC female, analog 2Vpp
adjustable from front panel
MULTIPLEX OPERATION
Composite Input Impedance: 2 Kohm unbalanced.
Composite Input Level: DS series -6 to +18 dBm
Input Connector: BNC female.
Composite Amplitude Response: ±0.1 dB, 30 Hz to 100
KHz.
Total Harmonic Distor on + Noise: 0.1% @ 400 Hz.
Intermodula on Distor on: 0.1%, 1 KHz/1.3 KHz, 1:1
ra o.
Transient Intermodula on Distor on: 0.1% 2.96KHz
square wave and 14 KHz sine wave.
FM S/N Ra o: -85 dB rms detector, -80 dB below ±75 KHz
devia on
AES/EBU OPERATION
Input Connector: XLR female, op cal TOS-LINK.
Data Format: S/PDF,AES/EBU, IEC958, EIAJCP340/1201.
D/A Converter: 24 bit.
Sampling Frequency: from 32 to 96 KHz.
AUDIO IP (op onal)
Lan: Audio IP and Web interface to control and confi gure
Transport protocol: RTP over UDP;
Protocols: RFE Codec: Alaw,OGG VORBIS, MP3, AAC
SHOUTCAST/ICECAST Codec : TX MP3, RX AAC, AAC+,
MP3, OGG(icecast 2.x)
SCA, RDS, AUX OPERATION
Input Impedance: ≥ 2 Kohm.
Input Level: -6 to +12 dBm.
Frequency Response: ±0.1 dB, 50 KHz to 100 KHz.
Input Connector: BNC female.
AUXILIARY CONNECTIONS
RS485: DB9 connector back panel.
CAN BUS (op onal): DB9 connector back pane
Telemetry Interface: connector DB25 back panel.
LAN: RJ45 connector back panel
MPX OUT: connector BNC back panel.
OPTIONS
RDS/RBDS Programmable Coder via PC.
OIRT or JPN version.
SNMP v2c
Audio Over IP
AES/EBU (only analog)
ELECTRICAL
AC Input Power: 90÷260 VAC 50/60 HZ single phase.
AC Apparent Power Consump on: 100VA @ 50W, 200VA
@ 100W, 450VA @ 300W, 750VA @ 500W, 1400VA @
1000W.
Cos: Ф> 0.98.
Cooling: Forced air.
Acous c noise:< -56 dBa @ 1 meter.
ENVIRONMENTAL
Opera ng temperature: -5°C to +50°C.
Max Opera ng Al tude: 3000 mt.
Rela ve Humidity Range: 0 to 90%.
PHYSICAL DIMENSION
Moun ng: Standard 19” chassis 2 U rack.
Size: W x 483 mm. D x 470 mm. H x 88 mm.
Weight: ~ 6,0 Kg. (50-100w), 10Kg. (300-1000W)