User's Manual

37
USER MANUAL - TRANSMITTER DS SERIES - 30 - 50 - 100 - 500 - 1000W
Rev 1.3
DB25 (TLC/TLS) Rear connector
Pin N. Type Func on Notes
1 Ground
2 Output - Analog Analog IPA (Power
Amplifi er Current)
0~5Vdc
Not present on 6kW TX
3 Output - Analog Analog Refl ected Power 5V@ nominal refl ected power
4 Input - Optocoupled External interlock So ware se able
as NO or NC
5 Input - Optocoupled Transmi er ON Remote mode only
as NO or NC
6 Input - Optocoupled Set memory M2 Remote mode only
7 Input - Optocoupled Set memory M4 Remote mode only
8 Input - Optocoupled Set memory M6 Remote mode only
9 Output - Digital General alarm relay - NO
contact
Latched
10 Output - Digital Power & Audio good
relay - NO contact
NON Latched
11 Output - Digital ON/Stand-byrelay - NO
contact
Latched
12 Output - Digital Local/Remote relay - NO
contact
Latched
13 Output - Analog +24VDC Service max 500mA
14 Output - Analog Analog VPA (Voltage
Power Amplifi er)
5V@ Maximum P.A. Supply
Voltage
Not present on 6kW TX
15 Output - Analog Analog Forward Power 5V@ nominal power
16 Input - Optocoupled Alarms reset Remote mode only
17 Input - Optocoupled Transmi er OFF Remote mode only
18 Input - Optocoupled Set memory M1 Remote mode only
19 Input - Optocoupled Set memory M3 Remote mode only
20 Input - Optocoupled Set memory M5 Remote mode only
21 Input - Analog External AGC (from an
external direc onal
coupler)
0~3Vdc
22 Output - Digital General alarm relay –
Common contact
23 Output - Digital Power & Audio good
relay – Common contact
24 Output - Digital ON/Stand-by relay –
Common contact
Appendix A - DB25 and DB9 pinout