User's Manual

Rev 1.3
USER MANUAL - TRANSMITTER DS SERIES - 30 - 50 - 100 - 500 - 1000W
44
5. Press the bu on “Upload” on the PC; the Upgrade begin and when the progress
bar arrive to 100%, if all is ok the led on the front panel of the TX became blinking
fast for few seconds.
6. A er the TX restart automa cally and the new fi rmware is uploaded.
7. To make sure the procedure was successfully verify under the “Menu” bu on
on the LCD display: here is showed the Firmware version loaded in the TX.
Make sure it correspond with the loaded one.
Then click on the “Menu” bu on; in the second page, on the right side of the
LCD you can verify the TX type and the serial number. Make sure that all the
informa ons are corrects.
For any request contact us via out  cke ng support system (www.rfebroadcast.
com/support) or sending an email to [e-mail].