User's Manual

45
USER MANUAL - TRANSMITTER DS SERIES - 30 - 50 - 100 - 500 - 1000W
Rev 1.3
Appendix D - Log event & Alarms list
The system is equipped with a register of alarms, consulted both on the display
that from web interfaces (where available). Each event that generates an alarm is
registered with date and  me at which the event occurred. In the following tables are
detailed individual alarm signals.
Text Alarms Descrip on
TX Power UP Switching on the device
TX Powe DOWN Turn off the device
TX in Local Mode TX is opera onal only in local mode
TX in Remote Mode TX is opera onal only in Remote mode
TX ON TX in power
TX Stand-By TX in stand-by
Alarm - OverCurrent Absorbed current higher than that allowed
Reset - OverCurrent Reset following to the Alarm - Over Current
Reset - FAULT It was carried out a reset of all alarms blockers
Alarm - PowerGood Power below the threshold of control set
Alarm - AudioGood No sound for a  me higher than the set value
Alarm - AC Line OFF No mains powered device in POE
AC Line ON Electrical network ok
Alarm - RF Burning Alarm RF Sec on likely outbreak transistor
Alarm - 485TX Fault Connec on 485 absent
Alarm - Pmax Power grater than nominal
Reset - Pmax Alarm Reset following Power greater than nominal
Alarm - Temperature RF temperature greater than 80°
Reset - Temperature Reset followinf RF temperature greater than 80°
Alarm - VSWR So . Prot. Alarm for increase Refl ected Power Block So ware
Reset - ACK VSWR HW Reset following to the Alarm VSWR HW
Alarm - VSWR HW Prot. Alarm for increase Refl ected Power Block Hardware
Playing ID-Code Ac va on ID-Code and airing
Alarm - Fan Fault Alarm Fans blocked
Alarm - Modules Fault Alarm RF Pallets Error
Alarm - Dera ng Pwr Alarm power reduc on due to Alarm VSWR
Power Reduc on Prog Power Reduc on ac va on
Local Access Denied If enabled password access denied locally
Web Accesss Denied Access denied on the web
AES/EBU Error Error of AES/EBU
Password Modifi ed Password Changed