User's Manual Part 1

DSPbR Series – User’s Manual
Document Number 00000.B Page 7/75
1.3 Health and Safety warnings
Only suitably qualified people should be allowed to install and commission this equipment after comprehending
and becoming familiar with all the safety and installation instructions contained in this manual. It will be
assumed that a qualified person will have a fundamental knowledge of the objectives and use common sense
where safety warnings are not necessary explicit.
The unit is heavy and appropriately considered a two-man lift. Handles are provided on the equipment to assist
in removal of the unit from the packaging and during installation.
On unpacking the equipment, familiarise yourself with equipment, reading and following all warning labels
attached to the equipment. Please ensure that the warning labels are kept in a legible condition and replace if
necessary.
Ensure all general, regional and site-specific installation and safety regulations are adhered to when working on
high voltage installations, as well as regulations covering use of tools and personal protective equipment.
It is the responsibility of the network operator or service provider to have in place and implemented, an
applicable and legally complaint Heath and Safety policy, detailing prevention measures to avoid health hazards
which may be associated with radiation from the antenna(s) connected to this equipment. Please ensure
familiarisation and compliance to country specific regulations on RF exposure.
Ensure all adjustable repeater settings comply with intended use and applicable regional regulatory
requirements.
Please note that only the authorised licence holder for the respective frequencies or frequency range is allowed
to operate this equipment.
Ensure that access to this equipment is restricted to qualified personnel only.
There is no On/Off switch on the unit – it becomes active as soon as AC or DC power is connected via the
provided AC mains cable or DC power source.
Do not allow the unit or any associated equipment to become wet or to be subjected to temperatures outside
the specified operating temperature range.
Do not operate the unit near any flammable substances or in a flammable atmosphere.