User's Manual Part 3

DSPbR Series – User’s Manual

Document Number 00000.B Page 58/75

Cell modem installation instructions

STEPS.

Cellular Modem Installation (Figure 25)

1. Remove Ref Gen + Aux board from DSPbR Sub Rack Frame

 Unscrew the two (2) screws retaining both the DSP Module and Ref Gen + Aux board into the frame

 Pressing the lever handles outwards, carefully “pull out” the DSP module.

 Once DSP module removed access to the Ref Gen board is easier, carefully pull out the Reg Gen +

Aux board.

2. Lay Ref Gen + Aux board on a flat anti-static surface

3. Remove the modem from the Cellular Modem Kit

4. Insert the modem into the mini-PCI connector (X801) at an angle of 30 degrees from the main PC board

Ensure the modem is fully inserted.

5. Press down on the floating end of the modem, until the retaining clips are securing the modem.

6. From the Cellular Modem Kit, unpack the U.FL to U.FL interconnect cable.

7. Align one end of the U.FL cable to the U.FL socket on the Ref Gen + Aux board (J105)

8. Firmly press on top of the U.FL connector

9. Align the other end of the U.FL cable with the main antenna port on the modem.

10. Firmly press on top of the U.FL connector

11. Ensure that the U.FL cable is not overhanging the Ref Gen + Aux board

12. Insert SIM card (refer to instructions below)

13. Correctly orientate and insert Ref Gen back into the DSPbR sub rack frame

14. Originate and insert the DSP module, back into the DSPbR sub rack frame

15. Tighten both DSP and Ref Gen board retaining screws.

SIM card Installation (Figure 26)

1. Unpack the SIM card.

2. Ensure there is no PIN enabled

3. Push along the top of the SIM card holder (X802) until the hinged SIM holder is loose

4. Lift the hinge SIM holder

5. Ensure the SIM card is correctly orientated and insert into the hinged holding sleeve.

6. Close the hinged SIM holder

7. Push along the top of the SIM card-holder until the hinged SIM holder is locked in place.

Once the cell modem has been fitted into the Ref Gen + Aux board, the allocated SIM card inserted and

securely locked down and the Ref Gen board secured and fastened into the sub rack frame, the modem can be