User Manual
Table Of Contents
- INTRODUCTION
- PACKAGE CONTENTS
- CONNECTIONS
- LED
- BASIC IP NETWORKING
- GETTING STARTED
- CONFIGURATION WIZARD
- CONFIGURATION MENU
- System Summary > Configuration
- System Summary > Associations
- System Summary > Statistics
- System Summary > Site Scan
- Basic > SNTP Setting
- Basic > LAN Setting
- Basic > WAN Setting
- Basic > MAC CLONE
- Wireless > Basic Setting
- Wireless > Advance Setting
- Wireless > MAC Address Control
- DHCP > DHCP Server
- DHCP > DHCP List
- Port Forward > Virtual Server
- Port Forward > ICMP Forward
- Port Forward > DMZ Setting
- Port Forward > UPnP Setting
- Firewall > MAC Filter
- Firewall > IP Filter
- Miscellaneous > Dynamic DNS
- System Tools > System Log
- System Tools > System Admin
- System Tools > Backup/Restore Settings
- System Tools > Firmware Update
- System Tools > Reboot
- FACTORY RESET
- PC CONFIGURATION
- TECHNICAL SUPPORT
IP Address: This displays the IP of your WAN as given by the ADSL modem.
Network Mask: This displays the network mask of your WAN as given by the ADSL modem.
Gateway Address: This displays the gateway address of your WAN as given by the ADSL
modem.
DNS Server: This displays the IP address of the DNS server as given by the ADSL modem. You
can manually set the DNS server if your ISP provides you with the IP address of the DNS server.
Secondary DNS: This displays the IP address of the secondary DNS server as given by the
ADSL modem. You can manually set the secondary DNS server if your ISP provides you with the
IP address of the secondary DNS server.
Username: Enter the username given by your ISP.
Password: Enter the password given by your ISP.
MTU: Maximum Transmission Unit indicates that packets larger than this size will be fragmented
before the transmission. Enter an MTU value only if required by your ISP. Otherwise, leave it as
the default setting.
Manual: You will only be connected or disconnect to the Internet when you click on the Connect
and Disconnect button.
Always on: The Router will auto-connect with the ISP when it restarts or when the PPPoE
connection is dropped.
Connect on Demand: Router will auto-connect to ISP when user launches any program that
require Internet connection on his PC.
Idle Time before auto-disconnect: You can set the Router in such a way that it will disconnect
after a certain period of inactivity. The time can be set in this field.
Basic > MAC CLONE
The default WAN MAC address is set to the WAN’s physical interface MAC address on the
Router. You can use the MAC Clone function to replace the default MAC address to that of the
Ethernet Card installed by your ISP. It is not recommended that you change the default MAC
address unless required by your ISP.
Enable MAC Clone: Tick to enable MAC Clone function.
MAC Address: Enter the MAC address you wish to clone or use the default MAC by
clicking on the Use Default MAC button.
Your PC MAC Address: This field reflects the MAC address of your computer.
Page 23 of 45