User Manual
Table Of Contents
- INTRODUCTION
- PACKAGE CONTENTS
- CONNECTIONS
- LED
- BASIC IP NETWORKING
- GETTING STARTED
- CONFIGURATION WIZARD
- CONFIGURATION MENU
- System Summary > Configuration
- System Summary > Associations
- System Summary > Statistics
- System Summary > Site Scan
- Basic > SNTP Setting
- Basic > LAN Setting
- Basic > WAN Setting
- Basic > MAC CLONE
- Wireless > Basic Setting
- Wireless > Advance Setting
- Wireless > MAC Address Control
- DHCP > DHCP Server
- DHCP > DHCP List
- Port Forward > Virtual Server
- Port Forward > ICMP Forward
- Port Forward > DMZ Setting
- Port Forward > UPnP Setting
- Firewall > MAC Filter
- Firewall > IP Filter
- Miscellaneous > Dynamic DNS
- System Tools > System Log
- System Tools > System Admin
- System Tools > Backup/Restore Settings
- System Tools > Firmware Update
- System Tools > Reboot
- FACTORY RESET
- PC CONFIGURATION
- TECHNICAL SUPPORT
5. In the box, click on Internet Protocol (TCP/IP). Make sure there is a tick in the box for
TCP/IP.
6. Use automatic for both the settings. Click OK and close all windows.
7. Windows 98SE and ME may prompt you for a reboot.
DHCP Client has been set up on your PC. Make sure you do a Factory Reset to the Router and
configure your broadband account again.
Page 38 of 45