User Manual

Shifttherodof3-PositionSwitch#2fromOFFtoSYNC-TEST,
1-IfButton5ofTransmitterAisalreadysynchronizedtothefiringmodule,
pressButton5ofthetransmitter,theLEDIndicator#4willblinkonce.
ItindicatesButton5issynchronized.Thesamewithotherbuttons.
2-Aftertheformerstepisdone,pressButton0.7ofthesynchronized
TransmitterB,theLEDIndicator#4willblink5timesinintervaltime0.7
seconds.ItindicatestheTransmitterBissynchronized.
Shifttherodof3-PositionSwitch#2fromOFFtoSYNC-TEST,pressand
don'treleasebuttonSYNC-TEST#3morethan6seconds,theLED
Indicator#4willbelit,donʼtreleaseyetuntiltheLEDblinkstwiceand
goesbacktothestatebeforepressingbuttonSYNC-TEST#3,allstored
codesoftransmittersarecleared.
D.Fire
6
Beforefiring,youneedtomakesurefollowing:
Firing Module
Remote
Igniter
Fire
Firing Commands
Firingmodulesandtransmitters/remotesarepoweredwell,noone
ofthemhasLowPower.
Theseunitsarealreadysynchronized.
IgnitersareconnectedwellandtestedOK.
Theantennasofthemodulesandtransmitters/
remotesshouldbepulledandextendedout.
Itʼsbetterifthefiringmodulesareplacedinthe
height1.5mormoreabovetheground.
Therodof3-PositionSwitch#2isatARM.
Thedistancefromthetransmitter/remotetothemodulesmustbe
lessthantheonesmarkedonthetransmitters/remotes,thenmore
than0.5m.
C4.CheckSynchronization
C5.DeleteSynchronization