Instructions / Assembly

9
For increased energy efficiency, some
water heaters have been supplied with
two 24” sections of pipe insulation.
Please install the insulation, according
to the illustrations above, that best meets
your requirements.
Typical vertical piping arrangement
Typical horizontal piping arrangement
Hot and Cold Pipe Insulation Installation
This water heater meets or exceeds the
National Appliance Energy Conservation
Act standards with respect to insulation
and standby loss requirements when the
energy cover in installed. The energy
cover must be installed in accordance to
the instructions provided.
Energy Efficiency
Items Provided:
1 - water heater energy cover
1 - water heater energy cover top
2 - tape strips - 3” x 40”
Installation:
1. With vinyl side out, wrap the cover
around water heater as shown in
Figure 1.
2. Apply 3 pieces of tape 6” long across
cover seam as shown in Figure 2.
3. Apply a strip of tape 32” long over
entire length of seam, as shown in
Figure 3.
Water Heater Energy Cover Installation Instructions
Figure 1
Figure 3
Figure 2