Specifications

TM002 Integrity 18 & 20L Service Instructions REV: E
D.O.I: 7/11/2007
This document is stored and maintained electronically by Service. All printed copies not bearing this statement in RED are deemed “uncontrolled”
17
875 series models are factory set and limited so that they cannot deliver water hotter than
48
o
C.
When no hot water is flowing, temperatures can be selected between 37
o
C and 43
o
C by
pressing and holding the temperature control buttons, to select temperatures above 43
o
C
press the temperature control button once for each selection.
A controller must be turned on and must display the ‘Priority’ indicator in order to allow
adjustment of water temperature.
When hot water is flowing, the temperature can be increased from 37
o
C to 43
o
C only.
The water temperature can be decreased from any setting whether hot water is flowing or
not.
Standard Controller
Note: If one or more controllers are installed, at least one must be on for the water heater
to operate. If all controllers are off the water heater will only deliver cold water.
Selectable Temperatures:
Kitchen Controller:
37, 38, 39, 40, 41, 42, 43, 44, 45, 46, 47, 48, 50*, 55*, 60
o
C*
Bathroom Controllers:
37, 38, 39, 40, 41, 42, 43, 44, 45, 46, 47, 48, 50
o
C*
* Temperatures above 48 degrees are not available on controllers fitted to 875 series
models as these units have a maximum selectable temperature of 48
o
C at all locations.
Controller
ON / OFF
button
Water
temperature
adjustment
buttons
Controller
display panel
(water temp or
water volume)
Controller
‘priority’ light
Controller
‘In use’ light
Water volume
button