User Manual
Table Of Contents
- Contents
- About Your Water Heater
- Water Heater Application
- Model Type
- Mains Pressure
- Water Heater Operation
- Reduced Hot Water Flow When Heat Exchanger Is Cold
- Gas Boosting For A Solar Water Heater
- How Hot Should The Water Be?
- Hotter Water Increases The Risk Of Scald Injury
- Safety
- Warnings
- Precautions
- General Maintenance
- Minor Maintenance Every Six Months
- Major Service Every Five Years
- Circulated Hot Water Flow And Return System
- Going On Holidays
- To Turn Off The Water Heater
- To Turn On The Water Heater
- Frost Protection
- Draining The Water Heater
- How Do I Know If The Water Heater Is Installed Correctly?
- Victorian Customers
- Does The Water Chemistry Affect The Water Heater?
- How Long Will The Water Heater Last?
- Temperature Control
- Temperature Control – Standard
- Temperature Control – Deluxe
- Deluxe Controller Functions
- Deluxe Controller
- Voice Prompt And Operating Tone
- Assistance Call Function
- Temperature Settings – Deluxe Controllers
- Temperature Adjustment – Deluxe Controllers
- Kitchen Controller – Deluxe
- Bathroom Controllers – Deluxe
- Bath Fill Function
- Bath Fill Function – Brief Guide
- Bath Fill Function – Explanatory Notes
- Turning Off Bath Fill Function During Its Operation
- Notes on the Bath Fill function:
- Opening a Second Hot Water Tap During Bath Fill Operation
- Early Completion of Bath Fill Operation
- Interrupting Bath Fill Operation
- Operation of the Bath Fill function whilst a Deluxe Controller has priority
- Water Supplies
- Save A Service Call
- No Display On The Controller
- Cold Water From The Hot Tap
- Water Is Too Hot Or Not Hot Enough
- Reduced Hot Water Flow When Heat Exchanger Is Cold
- No Water From The Hot Tap
- Water Flow Fluctuates
- Gas Booster Operating Too Frequently
- Fan Continues To Run After Water Heater Operation Stops
- Clouds Of White ‘Vapour’ From The Flue Terminal
- Pressure Relief Valve Discharging
- Error Code
- Higher Than Expected Gas Bills
- Installation – Water Heater
- Installation Standards
- Water Heater Application
- Water Heater Location
- Installation Within A Covered Area
- Pipe Cover
- Recess Installation
- Frost Protection
- Mains Water Supply
- Hot Water Delivery
- Circulated Hot Water Flow And Return System
- Reducing Heat Losses
- Water Temperature Diagrams
- Technical Data
- Dimensions – Water Heater
- Dimensions – Standard Controllers
- Dimensions – Deluxe Controllers
- Typical Installation – Outdoor Location
- Connections – Plumbing
- Connections – Electrical
- EZ LINK System Dual Installation
- Installation – Controllers
- Commissioning
- Draining The Water Heater
- Rheem Continuous Flow Gas Water Heater Warranty – Australia and New Zealand Only
- 1. The Rheem Warranty – General
- 2. Terms Of The Rheem Warranty And Exclusions To It
- 3. What Is Covered By The Rheem Warranty For The Water Heaters Detailed In This Document
- 4. Entitlement To Make A Claim Under This Warranty
- 5. How To Make A Claim Under This Warranty
- 6. The Australian Consumer Law
TEMPERATURE CONTROL – DELUXE
37
Turning Off Bath Fill Function During Its Operation
The bath fill operation can be interrupted by pressing the bath fill ( ) button before completion of the bath fill
operation.
If it is necessary to turn off the Bath Fill function before the operation is complete, during Step 7:
Press the bath fill ( ) button.
At this first press of the bath fill ( ) button:
The operating light will go out.
The bath fill operating light will flash.
The voice prompt will sound.
“bath filling has been stopped, please turn off the hot
water tap and press the bath fill ( ) button to finish”
The bath fill water volume display will go blank.
The temperature display will go blank.
The bath fill indicator light will go blank.
After a few seconds, water flow from the hot tap will
cease.
The bath fill water volume display will then show
0 litres.
The bath fill indicator light will recommence to glow.
Close the hot tap.
Press the bath fill ( ) button again.
At this second press of the bath fill ( ) button:
The bath fill operating light and bath fill indicator light
will go out.
The bath fill water volume display will go blank.
Note: If the hot tap has not been turned off, the voice
prompt will sound.
“please ensure the bath hot water tap is turned off”
X 10L
88
°C
X 10L
88
°C
X 10L
88
°C
X 10L
88
°C
X 10L
88
°C
X 10L
88
°C
“bath filling has been stopped,
please turn off the hot water tap
and press the
bath fill (
) button to finish”
°C
BATH (l)
BATH (l)
°C
0
°C
BATH (l)
“please ensure the bath hot
water tap is turned off”