Use & Care Manual With Installation Instructions for the Installer section on “If you need service” The purpose of this manual is twofold: one, to provide the installer with the basic directions and recommendations for the proper installation and adjustment of the water heater; and two, for the owner-operator, to explain the features, operation, safety precautions, maintenance and troubleshooting of the water heater. This manual also includes a parts list.
Safety Infatuation Safe Pacing fas Alias Models: Installation Instructions Ferraro Finn esplanade Wailer Supply Connections 4 Resupply iin nnn Phe salvation nn ny {3 Heat Traps ChE Installation Checklist: 18 Participial Heating 16 Operating Instructions Plating Instructions So 7 Water Temperature: co 1809 Care and Cleaning Rang 0H BOTHERATION i i 20 Buber ingestion ii 21 tented Beak-Down ai Troubleshooting Tips Before You Call Foreordain sans 22.
IMPORTANT SAFETY INFORMATION. READ ALL INSTRUCTIONS BEFORE USING. Be sure to bead and understand the entire Use and Care Manual before attempting to install or operate this water heater. It may save you time and money. Pay particular attention to the Safety Instructions. Failure to follow these warnings could result in serious bodily injury or death.
IMPORTANT SAFETY INFORMATION. READ ALL INSTRUCTIONS BEFORE USING. DANGER! A DANGER Water temperature over 125°F can cause severe bums instantly or death from scalds. Children, disabled and sidereal are at highest risk of being sealed. See instruction manual before setting temperature at water heater, Feel water before bathing or showering. Temperature Smiting valves are available, see manual.
DANGER! LIQUEFIED PETROLEUM (LP PROPANE OR BUTANE) AND NATURAL GAS MODELS LP and Natural gas have an odor ant added to aid in detecting a gas leak. Some people may not physically be able to smell or recognize this odor ant, If you are unsure or unfamiliar with the smell of LP or natural gas, ask the gas supplier. Other conditions, such as “odor ant fade”, which causes the deodorant fo diminish in intensity, ean lase hide or camouflage a gas leak.
IMPORTANT SAFETY INFORMATION. READ ALL INSTRUCTIONS BEFORE USING. A WARNING! For your safety, fhe Information In this manual rust be followed to minimize the risk of fire or explosion, electric shock, or fo prevent. property damage, personal Injury, or loss of Site. FOR INSTALLATIONS IN THE STATE OF CALIFORNIA California Law revives that residential water heaters genius-be braved, anchored or strapped to resist falling or horizontal-displaceraent doctor earthquake motions.
Installing the water heater. This water heater must be installed in accordance with these instructions, local codes, utility company requirements, and/or in the absence of local codes, use the latest edition of the American National Standard/National Fuel Gas Code. A copy can be purchased from either the American Gas Association, 400 N. Capitol Street NW, Washington, DC 20001 as ANSI standard Z223.1 or National Fire Protection Association, 1 Matriarchy Park, Quincy, MA 02269 as booklet PAN 54.
Installing the water heater. Inspect Shipment Inspect the water heater {or possible damage. Check the markings on the rating plate of the water heater to be certain the type of gas supplied corresponds to the wafer healer requirements. Combustion and Ventilation Air Proper operation of the water heater requires air for combustion and ventilation, Provisions for combustion and ventilation air must comply with referenced codes and standards.
Thermal Expansion Determine if a check valve exists in the inlet water fine. Cheek with your local water utility company. It nay have been installed in the cold water lin as a separate back How presenter, or it may be part of a pressure reducing valve, water meter or water softener. A check valve located in the cold water inlet line can cause what is referred to as a “closed water system”. A cold water inlet line with no check valve or back flow prevention device is referred to as an “open” water system.
Installing the water heater. A new combination temperature and pressure relief valve, complying with the Standard for Relief Valves for Hot Water Supply Systems, ANSI 221.22, is supplied and must remain in the opening provided and marked for the purpose on the water heater. No valve of any type should be installed between the relief valve and the tank.
WARNING: DO NOT attempt to convert this water heater for use with a different type of gas other than the type shown on the rating plate. Such conversion could result in hazardous operating conditions, Gas Supply The branch gas supply line to the water heater should be clean 1/27 black steel pipe or other approved gas piping material.
Installing the water heater. The water heater must be installed with the factory supplied draft hood in place, DANGER: Failure to install the draft hood and properly vent the water heater to the outdoors as outlined in the Venting section of this manual will result in unsafe operation of the water heater causing bodily injury, explosion, fire or death.
Hot and Cold Pipe Insulation Installation Typical vertical piping arrangement “Typical horizontal piping arrangement For increased energy efficiency, some to the illustrations above, that best meets ‘water heaters have been supplied with your requirements, two 247 sections of pipe insulation. Please install the insulation, according T&P Insulation Installation For increased energy efficiency, this 2 3/8” section of T&P insulation.
Installing the water heater. During Installation of this water no {3 DO cheek inlet gas pressure to ensure that it is within the range specified on the rating plate. UJ BO provide adequate air for combustion and ventilation as discussed in the Use and Care Manual and the National Fuel Gas Code 0 DO maintain proper clearances to combustibles as specified on the rating plate. 0 DO ensure that the venting system complies with the guidelines found in the Use and Care Manual and National Fuel Gas Code.
Installation Checklist A. Water Heater Location 0 Close to area of vent. 0 indoors and protected from freezing temperatures. [2 Proper clearance from combustible surfaces observed and water heater not installed on carpeted floor. 0 Sufficient fresh air supply for proper operation of water heater. CJ Air supply tree of corrosive elements and flammable vapors. 1 Provisions made to protect area from wale damage. {J Sufficient room to service heater.
Supplemental instructions for gas water heaters installed in potable/space heating applications. Local codes or lambing authority requirements may vary from the instructions or diagrams provided in this manual and take precedent over these instructions. Hit waiter : supply to Tee fitting must be installed as shown.
Lighting the water heater. Before operating this water heater, be sure to read and follow the instructions on the label pictured below and all other labels on the water heater, as well as the warnings printed in this manual. Failure to do so can result in unsafe operation of the water heater resulting in property damage, personal injury, or death . Should you have any problems reading or following the instructions in this manual, STOP, and get help from a qualified person.
Operating the water heater. ‘Water Temperature Setting... Maximum water temperatures scour just after the burner has shut off. To determine the water temperature, turn on a hot water faucet and place a thermometer in the water stream. The reference mark 4 on the rim of the temperature dial, represents an approximate wale temperature of Cy.
Care and cleaning of the water heater. Draining the Water Heater A CAUTION: Shut off gas to the water heater at the gas control {thermostat} gas cock or manual shut-off valve before draining water. DANGER: Before manually operating the temperature and pressure roller valve, make certain no one will be exposed fo the hot water released by the valve. The water drained from the tank may be hot enough to present a scald hazard and should be directed to a suitable drain to prevent injury or damage.
Care and cleaning of the water heater. Venting System Inspection Inspect the gas venting system and the chimney. Make certain the vent connector from the draft hood to the chimney is properly positioned and securely attached, Hf after inspection of the vent system you found soot or deterioration; call the local gas utility to correct the problem and clean the fue, or replace the flue, fue baffle, and venting system before resuming operation of the water heater.
Before You Call For Service... Troubleshooting Tips Save time and money! Review the charts on the following pages first and you may not need tu wall for service. This water heater incorporates a combustion shut off device that shuts the operation of the water heater down if undesirable combustion conditions occur. Such as the presence of flammable vapors or blockage of the combustion air inlet openings. Please contact a Qualified Service Technician if this occurs.
Before You Call For Service... Troubleshooting Tips Save time and money! Review the charts on the following pages first and you may not need to call for service. This water heater incorporates a combustion shut off device that shuts the operation of the water heater down if undesirable combustion conditions occur, Such as the presence of flammable vapors or blockage of the combustion air inlet openings. Please contact a Qualified Service Technician if this centaurs.
Replacement Parts. For and 60 gallon models using Natural or LP gas. Instructions For Placing a Parts Order All parts orders should include: The model and serial number of the water heater from the rating plate. Specify type of gas (natural or LP) as marked on fhe rating plate.
IF YOU NEED SERVICE 28 1. Should you have any questions about your new water heater, or if it requires adjustment, repair, or routine maintenance, it is suggested that you first contact your installer, plumbing contractor of previously agreed upon service agency. In the event the firm has moved, or is unavailable, refer to the telephone directory, commercial listings or local utility for qualified service assistance. 2.