Use and Care Manual

2
WARNING: If you do not follow these instructions exactly, a fire or explosion
may result, causing property damage, personal injury or death.
A.This appliance does not have a pilot. It is equipped
with an ignition device automatically lights the
burner. Do not try to light the burner by hand.
B. BEFORE OPERATING smells all around the
appliance area for gas. Be sure to smell next to the
floor because some gas is heavier than air and will
settle on the floor.
WHAT TO DO IF YOU SMELL GAS
 Do not try to light any appliance
 Do not touch any electric switch;
do not use any phone in your building
 If you cannot reach your gas supplier, call the
fire department.
C. Use only your hand to turn the gas control knob.
Never use tools. If the handle will not turn by hand,
don’t try to repair it, call a qualified service
technician. Force or attempted repair may result in a
fire or explosion.
D. Do not use this appliance if any part has been
under water. Immediately call a qualified service
technician to inspect the appliance and to replace
any part of the control system and any gas control
which has been under water.
OPERAT ING INSTRUCTIONS
1.STOP! Read the safety information above.
2. Set the thermostat to lowest setting.
3. Turn off all electric power to the appliance.
4. This appliance is equipped with an ignition device
which automatically lights the burner. Do not try to
light the burner by hand.
5. Remove front cover.
6. Turn gas shutoff valve to “off”. Handle will be
across the piping, do not force.
7. Wait five (5) minutes to clear out any gas. If you
then smell gas, STOP! Follow “B” in the safety
information above on this label. If you don’t smell
gas, go to next step.
8. Turn gas shutoff valve to “on”. Handle will be in
line with piping.
9. Install front cover.
10. Turn on all electric power to appliance.
11. Set thermostat to desired setting.
12. If the appliance will not operate, follow the
instructions “To Turn Off Gas To Appliance” and call
your service technician or gas supplier.
ihii li
TO TURN OFF GAS TO APPLIANCE
1. Set the thermostat to lowest setting.
2. Turn off all electric power to the appliance if service
is to be performed.
3. Remove front cover.
4. Turn gas shutoff valve “off”. Handle will be across
the piping. Do not force.
5. Install front cover.
FOR YOUR SAFETY READ BEFORE OPERATING
device which automatically lights the
smell
heavier than
electrical switch
electrical power to the appliance.
“OFF” position. Handle
“OFF” position. Handle will
be across the piping. Do not force.
“ON” position. Handle
will be across the piping, do not force.
will be in line with piping.
electrical power to the appliance.
electrical power to the appliance if
service is to be performed.