Use and Care Manual

48
1. Press the ON.
2. Press the. Then, is displayed and blinking.
3. Press the again so today’s day [For Example: Sunday] is blinking. Then turn the clockwise or counterclockwise until the ‘the desired day’ is
displayed.
4. Press the to save the Day.
5. Current Time is blinking,then turn the clockwise or counterclockwise until ‘the desired hour’ is displayed.Press the to save the Hour(Icon is lit).
Then the next ‘Time Icon’ will be blinking. Continue pushing the to select each 30 minute time block that is consecutive. To skip some time blocks
turn the to next desired time and press the to select the next time blocks. Press the to save the setting.
6. Press the to return to ‘Day’. Repeat steps 3-5 for each day of the week.
7. After completing all settings, press the three times to return to normal mode.
NOTE: The operation of the DHW preheat activated setting can be set separately.
Press the . The control panel must be off.
Press and hold the for 5 seconds to enter ‘Installer Mode’.
Turn the clockwise until 9:PH is displayed. Then press the so is blinking.
Turn the clockwise so ‘on’ and are blinking.
Then press the to save the setting.
[For Example] Today is Sunday DHW Preheat is scheduled to run Sunday 8:00am~10:00am and 6:00pm~8:00pm.
▪ E. SETTING FOR DHW PREHEAT ACTIVATION
▪ F. SETTING FOR DHW PREHEAT TIMERV
Hotter water increases the risk of scald injury. Scalding may occur within 5 seconds at a setting of 140°F (60°C). Water temperature over 125°F
can instantly cause severe burns, or death, from scalds. Children, disabled, and elderly are at the highest risk of being scalded. See instruction
manual before setting temperature at appliance. Feel water before bathing or showering!
DANGER
Figure 32 – DHW Preheat Activation Screen
Figure 33 – DHW Preheat Timer Screen