Use and Care Manual

9
Electrical Connections
To Fill the Water Heater
Make certain the drain valve on the
water heater is completely closed.
Open the shut-off valve in the cold
water supply line.
Open each hot water faucet slowly to
allow the air to vent from the water
heater and piping.
A steady flow of water from the hot
water faucet(s) indicates a full water
heater.
!
WARNING: Turn off electric power at the fuse
box or service panel before making any electrical
connections.
Also, the ground connection must be completed before
making line voltage connections. Failure to do so can
result in electrical shock, severe personal injury or
death.
Disconnect all power to unit before starting
maintenance. Failure to do so can cause electrical shock
resulting in severe personal injury or death
The unit must be grounded. Failure to do so can cause
electrical shock resulting in severe personal injury or
death.
If the water heater has been subjected to fire, flood or
physical damage, DO NOT operate the water heater
again until it has been checked by a qualified service
technician.
NOTICE: DO NOT use this appliance if any part
has been under water. Immediately call a qualified
installer or service agency to replace a flooded water
heater. DO NOT attempt to repair the unit! It must
be replaced.
EcoNet™ Communication
EcoNet™ communication is provided for integration with home automation,
energy management, and demand response systems. Connectivity is provided
through the via wireless (Wi-Fi).
Electrical Power
Hookup Terminals
Ground Screw inside
Junction Box
EcoNet™ Port
(Service Only)
CTA Adaptor
(Not included
in all models)
Right Side View
!
WARNING: DO NOT
turn on the electrical
supply or operate this
water heater unless it is
completely full of water.
The tank must be full of
water before water
heater is turned on. The
water heater warranty
does not cover damage
or failure resulting from
operation with an empty
or partially empty tank.
LeakGuard
TM
This water heater is equipped with
built-in leak detection and automatic
water shut off valve. The leak
detection device (LeakSenseTM)
detects the presence of water and
immediately alerts the electronic
control as the EcoNet app on the
cellular phone. When water is detected,
the electronic controls will shut down
the heating elements and the automatic
water shut off valve closes.
Self Check
The automatic water shut off valve
has a self check feature which runs
every 30 days once the water heater
is powered on. This feature works by
closing and reopening the automatic
water shut off valve. In case the valve
fails to reopen, the water heater will be
DISABLED. The water heater gives
alert when the automatic water shut off
valve fails to close.
!
WARNING: Failure to
follow the instructions
provided in this manual
may permanently damage
the unit and void the
manufacturer’s warranty.