Instructions / Assembly

17
CHANGE
CHANGE
SCROLL
DISPLAY
BEEP
INSTANCE
– NO
- YES
PRESS TO
SELECT
HIGH TEMPERATURE
High temperature mode will
allow the water temperature to
be set above 140 degrees F.
Press the DOWN arrow to
change seng then press
SELECT.
*Note: If screen is
dimmed press any
buon and release
to brighten the
display before
performing desired
acon.
Display mode is used to change
the temperature displayed
from Fahrenheit to Celsius.
Press either UP or DOWN
arrow to change.
Beep mode is use to turn all
the audible alarms on and off.
Press either UP or DOWN
arrow to change.
In this mode, error alarms and
water sensor detecon alarms
will not occur.
Instance number is used to
idenfy the water heater if
addional water heaters or
devices are connected to a
joint home control system.
The number may be changed
from 1 to 16 to idenfy this
water heater.