3250CL SETUP & OPERATOR MANUAL Performance Design Inc. | 2350 East Braniff St. | Boise, Idaho 83716 www.Rhin-O-Tuff.
Pro Series 3250CL Features: 11” Punching Edge 25 Sheet Capacity** Book Former Easy to Use Coiler 3-Year Limited Warranty
Features On-Off Switch Roller Start Roller Button Built-in Edge Guide Punch Button Book Former Carrying Grips Accessory Tray Waste Tray 2
Capabilities & Specifications Important Safety Notice •Always replace fuses or circuit breakers with the correct amperage and type. •Never bypass safety devices. •Hazardous voltages inside of machine. •No user serviceable parts inside of machine. Machine should only be opened by qualified repair personnel. Punch Capacity 20lb Copy Paper 25 Sheets 8mil Acetate Cover 2 Sheets Binding Capacity Max Coil Size Recommended 15mm Max Sheets Recommended 110 Sheets Technical Data Punch Die Pattern 4:1 .
Setup Back of Machine Power Cord •Position machine on solid surface •Plug power cord into wall outlet Unpackage machine On-Off Switch Fuse Turn power switch on Punch 1 2 3 •Insert paper, slide left, press punch button •Punch no more than 25 sheets of paper at one time •Punch no more than 2 sheets of plastic at one time Prepare book to be coiled by placing the Front Cover on top and the Back Cover on the bottom of the Book Body 4
Coil Determine the coil size needed by mm s 15 heet measuring the book thickness s 110 with guide on right side of the mm s 12 heet s accessory tray. 80 mm s Move book from larger to smaller 10 heet s 65 sizes until book just fits between m 8mheets s guides. 40 m 6m eets The number associated with the h s 25 slot (i.e. 8mm) signifies what size of coil to use.
Coil •Manually start Coil into the first 3-4 holes on right hand side of book •Press Coil Button to start roller spinning •Gently bring the coil into contact with the front side of the spinning roller while holding the book in a horizontal plane as shown above •Allow coil to spin into the book Crimping •Position pliers with the RED dot facing up, to the ceiling as shown •Holding pliers horizontally, insert the plier tips around the last coil of the book on the right hand side of the book •Close pliers com
Crimping Flip the entire book over so that the back cover is now on top •Position pliers with the RED dot facing up, to the ceiling as shown •Holding pliers horizontally, insert the plier tips around the last coil of the book on the right hand side of the book •Close pliers completely; this will cut and crimp the coil 7
Troubleshooting Symptom Solution Machine will not punch holes in paper •Plug power cord into wall outlet •Check wall outlet has power •Switch machine power switch to the “on” position Holes punch on the edge of paper •Clear paper chips from the throat of the punch die •Seat paper completely into the bottom of the punch die Holes punch off center of page •Move paper to the left, against the paper stop, prior to pressing the punch button Punch will not punch through completely •Remove a couple of she
Troubleshooting Symptom Solution Coil will not spin into book •Align pages of book such that the holes in the pages are all evenly aligned •Use book former to shape book to the contour of the coil Pliers will not crimp coil •Make sure that the RED dot is pointing up, to the ceiling and the right hand side of the book is being cut/crimped •Hold pliers horizontally •Grasp coil being cut firmly between thumb and forefinger will operating pliers Warranty The 3250CL coil binding system is covered by a 3 Ye
STRONG • SIMPLE • HONEST • CAPABLE TUFF AND BUILT TO LAST EASY TO USE & MAINTAIN TRUSTWORTHY & SOUND NEVER LETS YOU DOWN