User Manual

u
u
u
u
u
u
HD6500 and HD6700: Diagram 2.
Make sure there is no paper dust or paper chips
in the machine die slot before installing the die.
Remove the chip drawer before installing the die assembly.
Install the die by sliding it into the opening on the right hand side of the
machine. Make sure the punch pin retainer slides into the slot on the
back side of the opening.
Using two 5/16”-18 socket head cap screws provided with the machine
along with the hex key, secure the die assembly in the punch by
threading the screws through the holes in the punch and turning them
clockwise until tight.
Replace the chip drawer.
Make sure
the machine is turned off before installing the
die.
Diagram 2. (Image of HD6500)
Comb Die Backspace (Margin) Adjustment
u The comb die assemblies for the HD7700/H, HD7650, HD7100,
HD6500, HD6700 and HD7500/H have a four
position adjustable backspace. The positions are changed by pushing
the adjustor bar to the left for deeper settings (commonly used for
average to thicker sized books) and pulling the adjustor bar to the right
for shallower settings (commonly used for thinner sized books).
HD7000, HD7000 Plus,
7
!
WARNING
Crush hazard.
Keep hands away
from moving parts.
Lockout and disconnect
power before servicing.