User's Manual

1/2 2009/1/19

INSTRUCTIONS FOR OPERATION

SETING THE OPERATING CONTROLS

1.This unit operates on AAA 1.5 volts battery*2 (not included).

To prevent possible damage if the battery should leak , be sure to remove

the battery when the unit is not use .

2. Store the controller away from excess heat or humidity .

3. This remote control unit is required with 32 code combinations. To prevent

possible interference from or to other remote units such as garage door

openers, car alarm or security system . If you find that your fan and light

kit go on and off without using your control , simply change the combination

code in your transmitter and receiver .

4.Operation buttons on the panel of transmitter .

· · · · key – For fan High speed .

· · · key – For fan Medium speed .

· · key – For fan Low speed .

· key – For fan Lowest speed .

OFF key – For fan speed off .

LIGHT CONTROL key – For light brightness and ON/OFF control .

5.Start the fan :

Press the selected speed button to run the fan at the desired .

6.Turn off the fan :

Press the OFF button .

7.Light control :

Turn the light on or off by only touching the LIGHT CONTROL button .

Keep pressing the button in excess of 0.7 second it becomes a dimmer ,

the light varies cyclically in 0.8 second .

One of the important feature of this control is AUTO-RESUME . After power

on , it allows the light return to where it was off .

PAGE 1
INSTRUCTIONS FOR OPERATION SETING THE OPERATING CONTROLS 1.This unit operates on AAA 1.5 volts battery*2 (not included). To prevent possible damage if the battery should leak , be sure to remove the battery when the unit is not use . 2. Store the controller away from excess heat or humidity . 3. This remote control unit is required with 32 code combinations. To prevent possible interference from or to other remote units such as garage door openers, car alarm or security system .
PAGE 2
GENERAL INFORMATION : This REMOTE controller is designed to separately control your ceiling fan speed and light brightness . The Light ON/OFF button will control the light brightness ON/OFF . The red indicator on the transmitter will light when the button is pressed . INSTRUCTIONS FOR INSTALLATION AND OPERATION OF FAN SPEED CONTROLLER A. Setting the code on your new transmitter . 1. Remove battery cover . Press firmly below arrow and slide battery cover off . 2.