Lawn Mower User Manual

ASSEMBLY

TURBO 96 01/11 Assembly Section 3-6

ASSEMBLY

AXLE ASSEMBLY - HYDRAULIC OFFSET & SEMI-MOUNT

Attach rear axle (1) to lugs on rear of mainframe using bolts (2), and locknuts (8). Clamp caster wheel

assembly (2) to axle arm plate (3), using bolt (4), and locknut (9).

CONTROL RODS - PULL TYPE

Attach the two level-lift control rods to the lower lugs on tongue and to lugs on the rear axle tube using pins,

washers and cotter pins.

NOTE: The adjusting nuts on control rods should be to rear of machine and should always be adjusted with

equal tension on both rods. Figure Asm-R-0289 & Asm-R-0290.