Full Product Manual

- 9 -
RH22V
User Guide
FOR CLEAN OR REPLACE THE FILTER
4. Press the button to open the front cover and take out the filter. Wash the
filter under flowing water. Let it completely dry before reusing it again (Make
sure the filter is dry before next time using).
To replace with a new filter, press the button to open the front cover and
take out the use filter and put a new filter as shown in the drawings blow.
TO REINSTALL THE COMPONENTS
First, reinstall the dust cup back to the unit following
up the opposite procedures when detaching the dust
cup.
Then install the filter, the aluminum tube, the brush
or 3 in 1 tools for next time using as shown in the
drawing below.
If the roller brush becomes blocked or jammed with debris, the vacuum will shut
down, or be less efficient.
The roller brush may then need to be cleaned. Switch off the device first and then
carefully use a pair of scissors or a sharp knife to remove any items such as hairs that
may have become entangled.
HOW TO CLEAN THE ROLLER BRUSH
If the roller brush needs cleaning, push the lock button on the bottom of brush with a
finger or a coin, then uplift the lock button. Take out the brush. When the cleaning is
done, put the roller brush in place and push down the lock button. Note that the lock
button cannot be removed from the brush, only lift up.
NOTE: do not wash the roller brush with water.