Instruction manual

Your Rhino Security system incorporates the latest in high security & convenience features.
It is possible to customise your security system so that it suits your requirements perfectly.
Detailed below is the full list of programmable features that can either be turned on or
turned off.
We have set at the factory, the most common configuration chosen and these settings are
listed in the REGISTER Settings listed below. Once the desired features have been selected,
the selection is permanently retained in memory, even if power is removed.
To turn on or turn off any feature use the following procedure: eg to enable silent arming.
1. Arm then disarm the alarm system.
2. Within 10 seconds of disarming, turn the ignition key to on.
3. Press button 1 on the remote control (immediately after turning the ignition on) an
equal number of times to the selected feature’s code no. (eg 6 times for Audible
arm/disarm). Leave a 0.5 sec. gap between each press. The siren will chirp to confirm
each press.
4. Immediately turn the ignition to off after the last press.
5. The system will now confirm whether the feature has been turned on or off via visual
readout. One flash of the indicators means the feature is on. Two flashes means the
feature has been turned off.
PROGRAMMABLE
FEATURE
Press
Remote
This Many
Times
Indication INITIAL
FACTORY
SETTING
DESCRIPTION
Audible
Arm/Disarm
6 1 Flash On
2 Flash Off
ON This feature when turned off, stops the
siren from beeping for arm & disarm
confirmation i.e. only the blinkers will
flash.
Voltage Drop
(Current) Sensing
7 1 Flash On
2 Flash Off
OFF If deactivated, this feature will prevent
the alarm triggering via sensing a drop
in voltage in the vehicle’s electrical
system. This may be necessary where
engine thermo fans cut in
automatically or there are other
accessories active even when the
ignition is turned off eg fridges, car
phones.
Passive Arming 8 1 Flash On
2 Flash Off
OFF The alarm can automatically arm itself 30
seconds after you leave your vehicle
provided that the ignition is turned off, and
that at least one door has been opened
and closed ie. the owner has parked and
has exited the vehicle. This feature will not
lock the vehicle where central locking is
connected.
Auto Re-arm 9 1 Flash On
2 Flash Off
ON If system is disarmed and a door is not
opened, or the ignition turned on within 60
seconds, the s
y
stem will rearm & relock
4