Instruction manual

5
(where central locking is connected).
Silent Operation 10 1 Flash On
2 Flash Off
OFF When on, this feature stops the siren
from sounding on alarm trigger. The alarm
will still trigger, flashing the indicators etc.
Indication via optional paging system may
be desired instead of siren noise.Arm &
Disarm beeps are still given, & panic will
still sound the siren.
Bypass all inputs
except Ignition on
passive arm
11 1 Flash On
2 Flash Off
ON When on, this feature will only let igniton
trigger the alarm when it passive arms. If
off, all inputs will be active when the alarm
passive arms.
Central Closure 12 1 Flash 0.8
2 Flash 5 sec
0.8 sec You can select the lock & unlock outputs
to become a 5 second negative pulse
instead of 0.8 seconds. This feature is for
certain vehicles with vacuum central
locking or those with a central closure
wire (some BMW, Mercedes) ie doors
lock, electric windows wind up, sunroof
closes automatically.
Not Used 13 Not Used Not Used
Arming Delay
Adjustment & Door
Ajar Warning
14 Flash 14
times.
15 sec You can increase the arming delay period
in 4 second increments from the initial
minimum factory setting of 15 seconds up
to 95 seconds. Press Button 1 to
increase delay from present setting by 4
seconds with each press. A confirmation
chirp will be heard for each press. Press
Button 2 to decrease delay if required.
Turn the ignition to on to exit this mode.
Door Ajar Warning: When the arming
delay is set on 15 sec, if a car door i s
left open, when arming the siren will emit
an error chirp after the normal arming
beep. The alarm will also isolate the door
trigger input to prevent trigger in case
of a faulty door pin switch. If arming
delay is extended from 15 sec, this
feature will not work. This may be
necessary in vehicles that have an
interior light delay.
Impact Sensor
Sensitivity
Adjustment
15 Flash 15
Times
Maximum
Sensitivity
There are 25 levels of adjustment for
the impact sensing system. Press
Button 1 to decrease sensitivity by one
level from present setting with each
press. A confirmation chirp will be
heard for each press. Press Button 2
to increase sensitivity if required. Turn
the ignition to on to exit this mode. If no
buttons are pressed within 15
seconds the system will exit this mode
also.
Security Reset Code 18 No of
Flashes is
the Code
10 The security reset code relates to the
Security Override Mode detailed later
in this manual. Choose a Code number