Instruction manual

13
Wiring the Siren
* This wire is normally earthed and goes open circuit to trigger the siren
- Before connecting each wire, the identification label on the end of each wire should
be cut off.
Back up battery test
After the installation is complete, switch the siren to the on position. The siren will beep
once if the backup battery is OK and 5 times if the back-up battery is flat. The key
switch is an over-ride for siren, not the alarm system. If the sirens’ battery is still flat
after charging (being powered up) for 24hours, the battery should be replaced. Please
call your supplier.
Over-ride:
Turning the key switch to the off position will disable the siren (not the alarm system or
phone). Please note that if you turn the key switch off at the siren, the RAM main
module will still operate.
1. Off position - the siren is turned off.
2. On position - the siren is turned on.
3. Test mode - turn key from off to on. 1 Beep = OK, 5 Beeps = Flat battery
+12V: Connect to constant 12V
GND: Connect to Earth
*SIREN: Connect to siren wire on RAM (pin 6)