WHEEL RAKE CARRIER Published 05-06 Part No. 4702C OPERATOR'S MANUAL This Operator's Manual is an integral part of the safe operation of this machine and must be maintained with the unit at all times. READ, UNDERSTAND, and FOLLOW the Safety and Operation Instructions contained in this manual before operating the equipment. M&W 1020 South Sangamon Ave. Gibson City, Illinois 60936 217-784-4261 $0.00 ©2006 Alamo Group Inc.
TO THE OWNER/OPERATOR/DEALER All implements with moving parts are potentially hazardous. There is no substitute for a cautious, safe-minded operator who recognizes the potential hazards and follows reasonable safety practices. The manufacturer has designed this implement to be used with all its safety equipment properly attached to minimize the chance of accidents. BEFORE YOU START!! Read the safety messages on the implement and shown in your manual.
TABLE OF CONTENTS Specifications ............................................................................................................ 2 Introduction ................................................................................................................ 2 Decals ....................................................................................................................... 3 Decal Location ...............................................................................................
SPECIFICATIONS MODEL RC456 Weight (approximate) ............................................................................................. 585 Lbs. Overall Width of Tool Bar w\Wings Extended ................................................................. 91" Overall Length ........................................................................................................ 178 1/2" Hydraulics .............................................................................
DECALS These decals are installed for safety. They must be visible at all times and kept in good condition. The buyer of this machine assumes responsibility for maintaining these decals.
DECALS 13 6 7 RC456 12 2738332 8 10 9 4
DECALS 5 11 1 15 5
DECAL LOCATION ITEM PART NO. QTY.
SAFETY INSTRUCTIONS CAUTION! This machine should never be operated by anyone who is not familiar with the product and has not read the instruction manual. Do not operate the rake where people or animals are in the immediate area. Never allow passengers on the tractor while operating. When changing the configuration of the rake, make sure everyone is clear of the folding and hinged parts and avoid pinch points which can cause serious injury.
3. Install the tongue on the main frame using three 5/8" x 2" bolts, nuts, and lockwashers. On some models, a reinforcing plate is used. If so, install the plate beneath the tongue and main frame using six 1/2" x 1 1/2" bolts, nuts, and lockwashers. Install a hose support on the top bolt as the tongue is installed. If the optional extended tongue is used, install the extension between the main frame and tongue using the bolts provided and install a second reinforcing plate if used. 4.
The settings on the previous page are only approximate settings. The final position on the wing is determined by the desired width of the windrow. Moving the rake mounts forward on the wing makes the windrow wider. Moving the rake mounts rearward makes the windrow narrower. 10. Install the wheel rakes on the mount tube by inserting the rakes main frame tube into the tubes on the rake mounts.
CAUTION! Make sure the area around the machine is clear before lowering. Do not lower rakes when people or pets are near the rakes or folding mechanism. 4. Set the rake angle by repositioning the 5/8" bolt in the rake mounting bracket. Six holes are available for adjustments (See Illustration 4). See the rake operator's manual for more information on setting the rakes. 5. Working speed is normally 5 to 10 mph. Speed varies with different hay conditions or terrain.
ADJUSTING GROUND PRESSURE SETTINGS 7. Use this chart to adjust the rake ground pressure. When set properly, individual rake wheels should be light enough to float over the ground while maintaining a constant ground speed. Each adjustable chain is equipped with a threaded rod that is used to balance weight of the left and right side, and to make any fine adjustments. The chain has three flexible links.
TRANSPORTING To transport, retract the wings until they are in place against the tongue and install the locking pins so the pins capture the lugs on the wings. Secure the pins in place with hairpin cotter pins. CAUTION! Never transport rakes without locking pins in place. Avoid sharp turns during transport to prevent contact between the rakes and the machine. Slow down when approaching trees, fences, or ditches to avoid damage to rakes.
M&W LIMITED WARRANTY 1. LIMITED WARRANTIES 1.01.M&W warrants for one year from the purchase date to the original non-commercial, governmental, or municipal purchaser (“Purchaser”) and warrants for six months to the original commercial or industrial purchaser (“Purchaser”) that the goods purchased are free from defects in material or workmanship. 1.02.
TO THE OWNER/OPERATOR/DEALER To keep your implement running efficiently and safely, read your manual thoroughly and follow these directions and the Safety Messages in this Manual. The Table of Contents clearly identifies each section where you can easily find the information you need. The OCCUPATIONAL SAFETY AND HEALTH ACT (1928.51 Subpart C) makes these minimum safety requirements of tractor operators: REQUIRED OF THE OWNER: 1. 2. 3. 4.
Wheel Rake Carrier Wheel Rake Carrier - SOM - 05/06 Printed U.S.A.
An Alamo Group Company M&W® 1020 S. Sangamon Ave. Gibson City, IL 60936-9907 Please fold (do not tear), tape, and drop in any mailbox. PLEASE FILL OUT OWNER WARRANTY REGISTRATION INFORMATION SIGN, AND DROP LAST COPY IN ANY MAILBOX. IMPORTANT! TO PLACE THIS WARRANTY IN EFFECT, THIS WARRANTY REGISTRATION MUST BE FILLED OUT, SIGNED, AND MAILED WITHIN 30 DAYS OF DELIVERY DATE OF THIS MACHINE. DEALER AND PURCHASER MUST SIGN.
M&W WARRANTY REGISTRATION INFORMATION MONTH Serial No. M&W Model DAY YEAR Purchase Date Purchaser Last Name Street & No., RFD, Box, &/or Apt. No. First Name City M.I.
2. REMOVE WHITE COPY FOR CUSTOMER RECORDS. 3. REMOVE YELLOW COPY FOR DEALERS RECORDS. 4. MAIL LAST CARD POSTAGE FREE. M&W® WARRANTY REGISTRATION INFORMATION MONTH Serial No. M&W Model Purchaser Last Name Street & No., RFD, Box, &/or Apt. No. City DAY YEAR Purchase Date First Name M.I.
2. REMOVE WHITE COPY FOR CUSTOMER RECORDS. 3. REMOVE YELLOW COPY FOR DEALERS RECORDS. 4. MAIL LAST CARD POSTAGE FREE. M&W® WARRANTY REGISTRATION INFORMATION MONTH Serial No. M&W Model Purchaser Last Name Street & No., RFD, Box, &/or Apt. No. City DAY YEAR Purchase Date First Name M.I.