Operator`s manual

7
SAFETY INSTRUCTIONS
CAUTION! This machine should never be operated by anyone who is not familiar with the product and has not read
the instruction manual. Do not operate the rake where people or animals are in the immediate area.
Never allow passengers on the tractor while operating.
When changing the configuration of the rake, make sure everyone is clear of the folding and hinged parts and avoid
pinch points which can cause serious injury.
CAUTION! Make sure rakes are locked whenever they are in the folded position before working around the ma-
chine or before transporting.
IMPORTANT! The decals listed below are installed on the rake carrier for your safety. They must be visible at all
times and kept in good condition. The buyer of this machine assumes responsibility for maintaining these warning
decals. If they become damaged or unreadable for any reason, replace immediately.
ASSEMBLY
1. Layout and identify all parts. Many parts will be partially assembled by the manufacturer. The main frame and swing
arms are already assembled, along with the tension spring and adjustment chains, and the hydraulic cylinder is
installed by the manufacturer. The spindles and hubs are also installed on the axle.
2. Support the main frame assembly on sturdy stands and install the axle assembly under the main frame. Measure
from the rear of the main frame 17" to 18" to the back side of the axle tube. Secure the axle with three 4" x 5 1\2" x 5\8"
U-Bolts, lockwashers, and nuts (See Illustration 1).
The axle may need to be moved forward or backward until the caster wheels on the wings roll in the proper location on
the axle ramps (See Illustration 2). Tighten the U-Bolts when axle is properly located.